Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Your cleaning system requires some assembIy and is ready
for use only after it has been properiy serviced with the
recommended oil and fuel.
Jf you have any prohmems with the assembly of your
pressurewasher, please call the pressurewasher hempline
at 1o800o222o3136.
UNPACKTHE PRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkali contents, if any parts are missing or damaged, call
the pressure washer hetpline at 1=800=222=3136.
°
Main Unit
*
Handlewith 6ieaning Tank Assembly
o Accessory Tray
°
High Pressure Hose
*
Spray Gun
o
NozzleExtensionwith Quick Connect Fitting
,
HydroFoam
TM
Wash
°
Oil Bottle
o
Parts Bag (which includes the following):
o
Operator's Manual
,
Owner's Registration Card
,
Safety Goggies
,
DetergentSiphoning Hose/Filter
,
Bagcontaining 3 multi-coiored ProjectPro@Nozzles
°
HydroFoam
TM
Launcher
o
HydroFoam
TM
Launcher & Wash Instruction Sheet
°
FreshStart Fuel Cartridge
*
HandleFasteningHardwareKit (which includes):
°
Carriage Bolts (2)
°
Plastic Knobs (2)
°
Tree Clips (4)
Becomefamiiiar with each piece before assembling the
pressure washer. Identify ali contents with the iiiustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1=888=222=3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman
cJeaning system
wJJJ need assembJy
before
operation:
1.
Fiii out and send in registration card.
2.
Attach handle and accessory tray.
3.
Connect detergent siphon hose to pump.
4.
Add oii to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect pressure hose to spray gun and pump.
7.
Connectwater supply to pump.
8.
Attach nozzleextension to spray gun.
9.
Select/attach quick connect ProjectPro@nozzle to nozzle
extension.
Attach Handle and Aecesse_ Tray
1.
Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handie so it wiii slide
over the handie supports.
2.
Insert carriage boits (A) through holes from outside of
unit and attach a plastic knob (B) from inside of unit.
Tighten by hand.
3.
Piaceaccessory tray (A) over hobs (C) on handle
(viewing from front of unit). Push the tree clips (B) into
the holes untii they sit fiat against the accessory tray.
/
/
Insert multi-colored ProjectPro@nozzlesand other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.
Publicidad
Tabla de contenido
