Melodie Selection; Changing The Coding; Important - REV Ritter TGF-33 Manual De Instrucciones

Transmitter start-up:
5. Open the battery compartment
(5)
. Remove the battery isolation stripe. Place the
included battery (12 volt alkaline type: 23A) according to
the polarity instructions.
6. Press the doorbell button
the receiver, the signal tone sounds and the signal light
flashes.
Melody selection
You can make your melody selection with the switch
the switch briefly and the next melody will sound.
After the end of the melody, you can press the switch
to hear the next selection.
The selected melody remains stored until you change the
batteries.
After a battery change, the desired melody must be selected
(9)
again with the switch
Following melodies are selectable
01. Westminster
02. DING DONG (2 x)
03. Telephone ring
04. Circus Theme

Changing the coding:

The four code plugs on the transmitter and receiver (10) should
only be changed if the system activates itself without its own
transmission signal. Depending on your selection, disconnect
the plugs and place them only on the upper contact.
IMPORTANT: Plugging and pulling of the
plugs is free selectable. The change must
occur in the same plug position on both
devices (receiver and transmitter).
(4)
by unscrewing the screw
(6) (7)
. The pilot light
.
05. Banjo on my knee
06. Twinkle
07. It is a small world
08. Barking dog
lights up. On
(8)
(9)
. Press
(9)
again
Example:
12