Mountig; Troubleshooting; Care - REV Ritter TGF-33 Manual De Instrucciones

Mounting
Before fixing the device, check if the function at the selected
mounting place will be guaranteed. Because of constructional
conditions the range can be strongly influenced by little variation
of the chosen mounting place. Avoid mounting at metal surfaces
or reinforced concrete. This materials are shielding and reducing
the range.
1. You can only hang up the receiver (11).
2. Screw on the battery cover of the transmitter or fasten it with
duct tape or double-sided tape. Then place the transmitter
on the cover and screw it tight with the closure screw (5).
The name plate (12) can be inscribed after removal of the
cover (e.g. with a knife).

Troubleshooting

Gong not working
- Has the code been set correctly?
- Is the device switched on?
- Is the battery inserted correctly (polarity)?
- Is the battery empty?
- Is the device outside the range?
- Metal parts may reduce the range

Care

!
Store in a dry place
!
Always remove the batteries if the device is not to be used
for longer periods.
!
Clean the device with a damp cloth do not use cleaning
agents.
13