Testing The System - Graco UltraClear II 2M02 Manual Del Propietário

It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units if you
suspect they may have been damaged or have not been used for a long time.
1. If two adults are present, have one take the Parent Unit(s) to different locations, trying various volume settings, while the
other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the Nursery Unit to test it.
3. When testing, keep the level of your child's sounds in mind, and adjust the volume accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Units to the other channel setting.
To Listen To Baby
• Turn on Nursery Unit using the ON/OFF switch.
• Turn on Parent Unit(s) using the ON/OFF switch.
• Adjust the volume on the Parent Unit by turning the Volume Up/Down knob.
• The Sound Lights on the Parent Unit will illuminate as your child (or other objects) make noise near the Nursery Unit.
Please note that the Sound Lights and volume control on the Parent Unit are independent of each other. With the volume
turned all the way down, the Sound Lights will still illuminate as your child (or other objects) make noise near the Nursery
Unit.
To change the face plate:
• Pull the bottom of the face plate out from the bottom of the Nursery Unit.
• Lift the face plate up and pull the top out of the Nursery Unit .
• Reverse the steps to replace with the desired face plate.

Testing the System

Operation
Face Plate (on certain models)
5