Selecting Channels - Graco UltraClear II 2M02 Manual Del Propietário

• In case you are experiencing some interference, the channel on the Nursery Unit can be changed by switching the channel
button on the side of the unit. The Parent Unit and Nursery Unit must both be set to the same channel, either channel "A"
or "B" ("X" or "Y").
• Some models have a night light on the Nursery Unit that will illuminate when the button on the top of the unit is pressed
and will automatically shut off in 15 minutes or push the button again to turn the light off.
• Some models will display the temperature of the Nursery Unit. Push the button on the front of the Nursery Unit to switch
from °F to °C.
1. For optimum operation, it is best to use new batteries in the Parent Unit.
2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery
Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission.
4. Set both the Nursery Unit and Parent Unit to the same channel, "A" or "B" ("X" or "Y").
5. Turn on the Nursery Unit using the On/Off switch on the side. The green power light should come on.
6. Place the Parent Unit within five (5) feet (1.5 meters) of the Nursery Unit and turn on the Parent Unit using the On/Off
switch on the side of the unit. The green power light should come on.
7. Repeat same set-up procedure for second Parent Unit.
8. Your monitor is now ready for use.

Selecting Channels

Night Light or Temperature
Setting Up the Baby Monitor
4