EN
How to use:
Plug and switch on the unit.
Press
, when the LCD is bright, all the part could get started to set.
Note: factory pre-setting of program mode is made for the machine, customer can
change it according to their requirement.
The pre-setting of program mode is as following:
From Monday to Friday, the program will work as following setting, the heater will
work from 18:00 to 8:00 of the next day.
From Saturday to Sunday, the program will work as following setting, the heater
will work from 16:00 to 10:00 of the next day.
For the first time using, the screen will showed as follows:
Temperature setting (in manual and program mode)
Press SET to set the target temperature when first using (when normal using,
press directly + / - to set the target temperature)
After finish setting the target temperature, if there is no pressing, the twinkle
would stop after 10 seconds and setting will be finished automatically.
80