Troubleshooting - Champion MARQUIS WC 35 Manual Del Usario

Problem Possible Cause
Failure to 1. No electrical power
start or no to unit
air delivery • Fuse blown
• Circuit breaker
tripped
• Electric cord
unplugged or
damaged
2. Belt too loose or
tight
3. Motor overheated
• Belt too tight
• Blower bearings
dry
4. Motor locked
Inadequate 1. Insufficient air
air delivery exhaust
with cooler
running 2. Belt too loose
3. Pads plugged
Inadequate 1. Inadequate exhaust in
cooling house
2. Pads not wet
• Pads plugged
• Open spots in pads
• Trough holes
clogged
• Pump not working
properly
This warranty is extended to the original purchaser of an evaporative cooler installed and used under normal conditions. It does not cover
damages incurred through accident, neglect, or abuse by the owner. We do not authorize any person or representative to assume for us any
other or different liability in connection with this product.
Terms And Conditions Of The Warranty
For Eight Years from date of purchase, we will replace the original base assembly if water leakage should occur due to rust out.
For One Year from date of purchase, we will replace any original component provided by Champion Cooler which fails due to any defect in
material or factory workmanship only.
Exclusions From The Warranty
We are not responsible for replacement of cooler pads. These are disposable components and should be replaced periodically. We are not
responsible for any incidental or consequential damage resulting from any malfunction.
We are not responsible for any damage received from the use of water softeners, chemicals, descale material, plastic wrap, or if a motor of a
higher horsepower than what is shown on the serial plate is used in the unit.
We are not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.
How To Obtain Service Under This Warranty
Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response from the dealer,
contact the Customer Service Department: Champion Cooler, 5800 Murray Street, Little Rock, Arkansas 72209. 1-800-643-8341.
info@championcooler.com.
This limited warranty applies to the original purchaser only.
110496-1

Troubleshooting

Remedy
1. Check power
• Replace fuse
• Reset breaker
• Plug in cords or
replace if
damaged
2. Adjust belt tension
3. Determine cause of
overheating
• Adjust belt
tension
• Oil blower
bearings
4. Replace motor
1. Open windows or
doors to increase air
flow
2. Adjust belt tension
or replace if needed
3. Replace pads
1. Open windows or
doors to increase air
flow
2. Check water
distribution system
• Replace pads
• Repack pads
• Clean trough and
unplug holes
• Replace or clean
pump (Unplug
unit)
Limited Warranty
Problem Possible Cause
Motor 1. Low voltage
cycles on 2. Excessive belt
and off tension
3. Blower shaft tight or
locked
4. Bearings dry
Noisy 1. Bearings dry
2. Wheel rubbing
blower housing
3. Loose parts
Excessive 1. Inadequate exhaust
humidity in
house
Musty or 1. Stale or stagnate
unpleasant water in cooler
odor 2. Pads mildewed or
clogged
3. Pads not wetting
properly
• Trough holes
clogged
• Pump not
working properly
Water 1. Float arm not
draining adjusted properly
from cooler 2. Overflow assembly
leaking
Remedy
1. Check voltage
2. Adjust belt tension
3. Oil or replace
bearings (Unplug
unit)
4. Oil bearings
1. Oil bearings
2. Inspect and realign
(Unplug unit)
3. Tighten loose parts
1. Open doors or
windows
1. Drain pan and
clean pads
2. Replace pads
3. Check water
distribution system
• Clean
• Replace or clean
pump (Unplug
unit)
1. Adjust float
2. Tighten nut and
overflow pipe.
5