Troubleshooting; Maintenance; Environmental Protection - Truper ROTI-12AC Instructivo

Troubleshooting

Problem Cause
The drill is losing • Low battery.
efficiency.
The trigger cannot be • The rotation direction button is in the blocked
pressed. position.
The trigger can be • Low battery.
pushed but the chuck
is not rotating.
The torque regulator • The regulator is set in the wrong torque.
stops the operation.
The battery is leaking. • A very small leak may be present in extreme
temperatures or after a rough work. This is
normal.
• Intense or very evident leaking is due to a
damaged battery.
The battery is not • Battery is not correctly set in the charger.
charging and the • The charger is not connected correctly in the
charge level indicator power supply.
light is not on.
The drill gets hot • This heating is normal because it absorbs the
after long periods of energy from the motor cogs and the electricity
time. generated during the work.
The battery gets hot • This is normal. The energy extracted from the
during the job. battery while the drill is running makes it hot.
The battery gets hot • This is normal. It results from the chemical
while charging. reactions taking place inside the battery while
charging.
The charger gets hot • This is normal. It results from the chemical
while charging. reactions taking place inside the battery while
charging.

Maintenance

Cleansing and Care
• Keep the ventilation slots clean and free of obstructions
to guarantee the adequate cooling down of the motor.
• Inspect regularly all the assembly screws and double
check the correct tightness. If one of the screws is lose,
tighten immediately.
• Use a soft and clean cloth to clean the tool. Never use
alcohol or detergent. Disconnect the tool and remove the
battery before cleaning.

Environmental protection

Power devices and batteries shall not be discarded with household garbage. Please hand over this tool and the battery
with the contacts insulated with electrical tape to a recycling facility. Verify the address of the nearest recycling site
closest to your community.
Solution
• Charge the battery.
• Move the rotation direction button to the rotation
or reverse position.
• Charge the battery.
• Adjust the regulator into a torque that allows to
work. Try with the next torque level.
• Clean immediately with water and soap the liquid
from your skin or clothes.
• Replace the battery immediately.
• Insert the charger connector correctly to the battery.
• Check the charger plug. It shall be well connected
into the power supply.
• Give the drill 5-minutes to cool-down.
• Stop the drill for a 5-minute span to allow the
battery to cool down.
Service
Service to the tool shall only be carried out in a
Authorized Service Center.
Maintenance and service carried out by non-certified
personnel may be dangerous and can cause personal
injuries and makes the Warranty void.
9
ENGLISH