Basic Operation; Volume Control - QFX J-220BT Guia De Inicio Rapido

AC Operation
1. Before connecting the unit to an AC outlet, check the operating VOLTAGE of the unit is
identical with the VOLTAGE of your local power supply.
2. Connect the supplied AC power cord to the AC socket at the back of unit.
3. The battery will be automatically disconnected when the AC Power cord is plugged into
the socket.
Battery Operation
Unplug the AC cord from AC jack. This unit requires UM IX4 (not included), open battery
insert the batteries in the battery compartment at the downside of the unit, be careful of
position according to the notes. Close the battery cover.
Battery Operation
1. Select required band (FM/AM/SW1-SW2) with BAND selector
2. Select desired station by rotating the TUNING control
3. The built-in antenna is directional. When receiving FM or SW-1-SW-2 broadcast, pull
out the telescopic antenna in full length; the strongest reception can be achieved by
rotating and searching for the strongest signal.
4. Adjust VOLUME control to your listening preference.
5. To turn off the radio, set the function selector to TAPE (OFF) button. Listen with
headphones (not included).\For private listening, you can use headphones with the unit.
Connect the headphones (not included) to the headphone jack at the side of the unit. The
sound from the speakers automatically turn off when headphones are connected to the
unit.
Playback Operation
Cassette Play
1. Set the function selector to the TAPE position
2. Press the STOP/EJECT button to open the cassette door. Insert the cassette so the
open side faces up. Close the cassette door.
3. Use the following buttons and controls for cassette play:
PLAY:
•Press Play to begin playing the cassette tape
F.FWD:
•Press to rapidly advance the cassette tape forward.
REWIND:
•Press to rapidly rewind the cassette tape back.
STOP:
•Stop playing or release the F.FWD and REW button.
AUTO STOP:
•Cassette tape will automatically stop when it reaches the end.
PAUSE:
•Press to stop playing or recording. The use of the PAUSE button does not disturb the
setting for either play or record. This function should be used for a temporary stop. It is
best to use the pause button when recording. Press PAUSE again to resume playing
back or recording.

VOLUME CONTROL:

•Slide the control to the right to increase the volume. Slide the control to the left to
decrease the volume.

BASIC OPERATION