Introduction; Intended Use; Features; Package Contents - Parkside PFE 50 A1 Traducción Del Manual De Instrucciones Original

ELECTRIC PAINT ROLLER
PFE 50 A1

Introduction

Congratulations on the purchase of your
new appliance. You have selected a
high-quality product.
The operating instructions are part of this
product. They contain important informa-
tion on safety, usage and disposal. Before
using the product, familiarise yourself with all
operating and safety instructions.
Use the product only as described and for the
specified areas of application. Please also pass
on these operating instructions to any future owner.

Intended use

This appliance is intended exclusively for the appli-
cation of water-based dispersion and latex paints
to interior and exterior walls. Use this power tool
only if you can fully appreciate all the functions
and perform them without any restrictions or have
received the appropriate instruction.
Any other usage of or modification to the appliance
is deemed to be improper and carries a significant
risk of accidents. The manufacturer accepts no re-
sponsibility for damage(s) resulting from improper
usage. The appliance is not meant for commercial
use.

Features

Paint roller 20 mm
Inner roller
Cap
Roller bracket
On/off switch pump
Handle with supply hose
Base unit
Height-adjustable paint bucket attachment
Intake hose
Main switch
Mains plug
Extension adapter
Paint roller 12 mm
Lubricating grease
│ GB │ IE
■ 12

Package contents

1 electric paint roller PFE 50 A1
1 paint roller 230 mm, pile height 20 mm
(for textured and rough surfaces)
1 paint roller 230 mm, pile height 12 mm
(for smooth and slightly textured surfaces)
1 lubricating grease
2 adapter for extension poles

Technical data

Nominal power:
Rated voltage:
Flow rate:
Protection class:
Noise and vibration data:
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level: L
Uncertainty:
Sound power level:
Uncertainty:
Wear hearing protection!
Vibration emission value: a
Uncertainty:
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance
with the standardised measuring procedure
specified in EN 60745 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
50 W
230 V ~ , 50 Hz
(alternating current)
Water: 750 ml/min
Wall paint: 650 ml/min
II / (double shielded)
≤ 74.9 dB (A)
pA
K = 3 dB (A)
L ≤ 85.9 dB (A)
WA
K = 3 dB (A)
< 1.178 m/s 2
h
K = 1.5 m/s 2
PFE 50 A1