Uline H-5759 Manual Del Usuario página 3

NOTE: Drawer comes pre-assembled. See
next page for instructions to attach drawer to
workstation.
NOTE: The drawer and suspension have a 70 lb.
weight capacity.
ATTACHING TO NON-STEEL TOP
1. Remove drawer (1) from housing (2).
2. Using housing as template, mark location of four
holes for wood screws onto underside of tabletop.
(Recommendation: 1/2" offset from front of tabletop).
3. Using 5/32" drill bit, drill holes into tabletop, drilling
about 1/2" to 3/4" deep.
4. Secure housing to underside of top, using four
14-3/4" hex head slotted wood screws.
#
5. Insert drawer into housing.
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with
the steel top. (See Figure 4) Channels may
extend past the drawer assembly.
Figure 4
1. On the underside of the table, slide mounting
channels front to back into table flanges. When
channels are aligned, mounting holes should be
approximately 14½" apart. Secure each channel
with two 1/4"-20 x 5/8" bolts. (See Figure 5)
2. Open the drawer. Attach the drawer assembly to
the mounting channels using four 1/4"-20 x 1/2"
bolts. (See Figure 5)
Figure 5
3. Close the drawer.
PAGE 3 OF 27
ASSEMBLY CONTINUED
Mounting Channels
ATTACHING MULTIPLE DRAWER UNITS
1. Remove drawer (1) from housing (2).
2. Bolt housing together with four 1/4-20 bolts and nuts.
3. Insert drawer into housing.
UPRIGHT ASSEMBLY
1. Carefully set table upright and recheck all nuts, bolts
and screws for tightness.
2. Position upright (6) on back corner of the tabletop.
The mounting plate should be positioned directly
over the previously drilled holes. Fasten four 2⁄"
bolts and washers through uprights, tabletop and
legs using 10 mm wrench. Secure with flange nuts
on underside of table. (See Figure 6)
NOTE: Steel tops already come with drilled
holes through top.
3. Repeat with other upright. (See Figure 6)
Upright
2¾" Bolt
Washer
Flange
Nut
Leg
Figure 6
Mounting
Plate
Upright
0121 IH-5759