HoMedics TOTALCLEAN Guia De Inicio Rapido

READ AND SAVE THESE INSTRUCTIONS
Before Turning the Unit On
• Take the air purifier out of the box and remove the clear, protective plastic bag.
• Place the air purifier on a firm, level surface.
• Make sure the air purifier is off and unplugged to confirm that the filters are firmly in place and did not become loose during shipping.
1. To check filters, open the rear
cover by gently pushing on
the release tab on the top of
the rear grille cover.
4. Locate the PetPlus Odor Filters in
the rear grille cover. Remove the
PetPlus Filters from the plastic
bags and set aside. Check to
make sure the Pre-Filter is seated
in place on the frame of the grille
cover.
POWER ON/SPEED SETTINGS
Plug unit into a 120 volt AC electrical outlet. Press the Power Button to turn the air purifier on. Press the SPEED + or SPEED -
button to adjust the fan speed.
QUICK START GUIDE
2. Open the grille cover outward
until the tabs at the bottom
of the grille cover easily slide
away from the unit.
5. Place the PetPlus Odor Filters
into the rear grille cover, seating
them on the rails, with the pull
tabs facing outward at the top
of each filter.
3. The True HEPA filters will be
resting inside the unit. Make
sure the filters are firmly seated
inside of the unit.
6. Place the tabs at the bottom of
the grille cover into the base of
the unit. Gently push the grille
cover back into place until you
hear a click sound indicating that
the grille cover is firmly latched.
QS-ATPET02B
Made in China