Titan Controls Apollo 4 Guía Sencilla

®
Apollo 4
120 Volt In-Line Timer
Easy Guide G
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Place Apollo 4 near equipment to be operated, but
away from water, mist, spray, etc.
2. Plug Apollo 4 into the ballast to be controlled.
Important: If your ballast has 2 power inlet recep-
ticles, make sure to plug the Apollo 4 into the 120
volt recepticle. If you want to use 240 volt power,
you must use an Apollo 5.
3. DO NOT exceed 10 amps.
4. Set the 24 hour timer to the correct hour and
approximate minute.
5. Push the captive trippers to the OUTER RING for
the entire period the ballast is to be 'ON'.
6. Push the captive trippers to the INNER RING for
the entire period the ballast is to be 'OFF'.
7. Verify that the input power is maximum 120 volts.
Exceeding this voltage will destroy your ballast and
void your warranty.
8. Plug the Apollo 4 into a 120 volt outlet.
9. Ballast will cycle "On" &"Off" at desired settings
until power is defeated.
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Controller Specifi cations
Size: 5"H x 4"W x 2"D
Weight: 1 lb.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 10 amps
Hertz: 60 Hz
Switch Rating: 1350 Watt Tungsten
Operating Temperature: 40
Storage Temperature: 32
Cord Set: 16/3 AWG SJTW
Controlling a Ballast using
120 Volt
Power Input
®
o o o o
to 125 F | 5 to 53 C
o o o o
to 135 F | 0 to 57 C
an In-Line Timer
Apollo 4
to 120 Volt Ballast