Escalade Sports Stiga T8721 Manual Del Usuario página 6

10
CAUTION:
25. Choose a name panel #5 on either side of the table and install
one safety latch #8 into the right-hand hole on that name panel
as shown in Figures 11 & 12. Use one screw #10 one washer
#17 and one hex nut #16. NOTE: Flange on safety latch
must extend over top of name panel as shown in Figure
11. Safety latch must pivot freely.
26. Go to the other side of the table and install the second safety latch
into the right-hand hole on the other name panel #5.
Safety latches must be attached diagonally across
from each other See Figure 12. .
Figure 12
8
INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
NOTE:
Figure 11
6