Installing The Batteries - Targus amr04eu Manual Del Usuario

Targus Bluetooth Media Remote for iPad Targus Bluetooth Media Remote for iPad

Installing the Batteries

0 6
1 7
2 8
3 9
4
5
1 Remove the battery cover located on the bottom of the
remote.
2 Insert the supplied battery, making sure that the positive (+)
and negative (-) end matches the polarity indicators inside
the battery compartment.
Establishing the Connection
1. Turn on the remote by sliding the power button to the ON
position.
2. Switch ON the Bluetooth function of your iPad.
6
0
1 7
2 8
3 9
4
5
0 6
1 7
2 8
3 9
4
5
4 5
Targus Bluetooth Media Remote for iPad Targus Bluetooth Media Remote for iPad
3. Press the Connect button
of your Targus Bluetooth Media Remote to enable discovery
mode. The low power indicator light will flash blue when the
remote is in discovery mode.
4. Once the remote is listed as a found device in the bluetooth
menu on the iPad, tap on the name and you will be prompted to
enter a pass key as shown.
"Bluetooth Media Remote" would
like to pair with your iPad.
Enter the passkey "XXXXXX"
on "Bluetooth Media Remote",
followed by the return or enter Key.
5. Use the number buttons in the battery compartment of your
remote to enter the passkey shown on the pop up message,
followed by the enter key.
6. Bluetooth Media Remote for iPad is now connected with your
iPad and the blue light on the front of the remote will stop flashing.
inside the battery compartment
Cancel
0 6
1 7
2 8
3 9
4
Enter
5
Connect
5 4