Spypoint LINK-MICRO-LTE Manual De Instrucciones página 9

CELLULAR SETUP
First transfer time: Allows you to choose the time when the
camera makes its first transfer of the day.
Transfer frequency: Allows you to choose the number of daily
transfers.
ADVANCED OPTIONS/CONFIGURATION
Schedule: Allows you to set the period of operation for each day
of the week. For a 24-hour operation mode, both the start and
stop times must be 12 AM.
NOTE
Camera transfers are set by default to 4-hour intervals determined
from the time you activated your camera. For example, if your
camera was activated at 1:42 p.m., the next transfer will take
place at 5:42 p.m.
STARTING YOUR CAMERA
1. Turn ON the camera.
2. The green STATUS light will flash while searching for a signal
(can take a few minutes).
3. The STATUS light will light up in one of the following 3 colors:
Red: Insufficient signal
Orange: Acceptable signal
Green: Optimal signal
4. When the top right light flashes red, 30 seconds remain
before the photo mode is turned ON. This allows you to leave
the area without being photographed.
9