PROPER INSTALLATION AND LOCATION
1) Dispenser is for
indoor use only. Do not use outdoors.
2) To prevent algae growth, find a
location for your dispenser that is
protected from direct sunlight and
other sources of heat (e.g., radiators,
baseboard heaters, cooking appliances,
etc). Do not use when relative
humidity is greater than 90%.
3) Do not install the dispenser where the
surrounding air temperature will be
above 100°F (38°C) or below 50°F
(10°C).
GROUNDING INSTRUCTIONS
WARNING –
electric shock.
•
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electric shock.
•
This appliance is equipped with a power cord having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly installed and grounded.
•
Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
•
If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have
it replaced with a properly grounded 3-prong wall outlet.
•
Do not under any circumstances cut or remove the third (ground) prong from the power cord.
•
Do not use an adapter plug with this appliance.
•
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician install an outlet near the appliance
•
For best operation, plug the appliance into its own electrical outlet on a dedicated circuit to prevent
flickering of lights, blowing of fuse, or tripping of circuit breaker.
Improper use of the grounding plug can result in a risk of
4
4) Place the dispenser on a level surface
that can support its weight with a full
water bottle on it.
5) To ensure that your water dispenser
works at the maximum efficiency,
leave at least 8 inches of clearance
between all sides of the dispenser and
any walls.
6) To prevent damage to dispenser, do
not plug dispenser into the power
outlet until reading the instructions
first!