Polk Audio n1 surroundbar Manual De Instrucciones página 7

How To Connect Your Bar
SURROUNDBAR
3A
20V
60W SUB OUT
How To Optimize The Sound
When TV Speakers Are On
You should hear sound from the bar. If you don't,
turn up the volume on the bar using its volume
control buttons.
If your bar is connected to your TV, there's a very
good chance your TV speakers are also playing.
It's impossible to give specific instructions on how
to turn off the speakers for every TV, but here's a
way to do it that covers many of the TVs out there.
1. On your TV remote control, find a "menu"
or "setup" button.
2. Press this button. You should see
an on-screen menu.
3. Next, look for an option to control audio
functions and select it.
Polk Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
8
SOURCE
3 2 1
DIGITAL OPTICAL
AUDIO OUTPUT
The setting to turn off your TV's internal speakers
should be here.
If you can't turn off your TV internal speakers, don't
worry. Your N1 SurroundBar will make your TV
sound much better. To enjoy the best performance
from your bar, you'll want it to play louder than your
TV. Use the following steps to adjust the volume
balance between your TV and the bar:
1. If necessary, program your bar to respond to
the volume up and down control commands
of your TV remote. (See "How To Setup
A Remote Control For Your SurroundBar"
on pages 8-9.)
2. Turn your TV volume all the way down using
the control buttons on your TV.
3. Then, using the volume keys on your bar,
set the volume to a normal listening level
(do not use the remote control).
After you make these adjustments, your N1
SurroundBar should always be louder than your
TV speakers. Then use the TV remote control
to adjust the volume as you normally do.
Note: Remove the protective
cap prior to inserting cable.
XBOX CONSOLE