wolfcraft MASTER cut 2000 Traducción Del Manual De Instrucciones Original página 27

INTRODUCTION
• PLEASE NOTE: Do read all safety & other instructions that have come with the Master cut 2000 and with the power tools you use for work.
Failing to observe the safety & other instructions may cause electric shocks, fire and/or severe injuries.
• Do keep the operating instructions for future reference in a safe place.
TECHNICAL DATA
dimensions (put up for use):
dimensions (folded up):
worktop:
maximum height of work piece:
maximum cutting width with parallel guide:
maximum cutting length:
maximum dimension of work piece:
diameter of the clamping holes:
pattern of the clamping holes:
load-bearing capacity:
weight:
SYMBOLS AND THEIR MEANING
Warning against a general danger
Read the instructions!
Goggles must be worn.
Hearing protection must be worn.
Dust mask must be worn.
Pull the plug.
ASSEMBLY TOOLS
2 allen wrenches: SW 5, SW 2.5
(included in the scope of delivery
INTENDED USE
The Master cut 2000 is a precision saw table and a work station. It is suitable for
• the installation of a hand-held circular saw with splitting wedge on the machine plate, with the saw blade having a maximum diameter of 200 mm
and a maximum cutting depth of 70 mm. Do only use saws within the above maximum dimensions of the base plate (see Fig. 13).
Use the correct gap insert. It makes the Master cut 2000 a stationary circular saw bench.
• using it as hand-held circular saw to be moved on the guide bar for processing large ob-jects, such as doors, worktops etc. In this case,
the machine plate with the gap insert can be used as guiding carriage for the guide bar.
• using it as jigsaw table. In this case, use the gap insert for jigsaws and routers.
• using it as milling table exclusively in combination with the parallel milling guide (Art.-No. 6901000) and for 230-V routers with a maximum rating
of 1800 W. Do not use cutters with a diameter of more than 27 mm! The milling machine must not be used in combina-tion with the guide bar.
Use the gap insert for routers and jigsaws with the spacer rings.
• being used as workbench for processing work pieces (e.g. drilling, grinding etc.). The work pieces can be safely fixed with the help of the
aluminium quick clamps or with the wolf-craft one-hand clamps (Art. Nos. 3456 and 3457) by using the many clamping holes on the worktop.
• Do observe the manufacturer's safety & other instructions for the machines used as well as the safety instructions for the machine table.
• When disposing the Master cut 2000, please observe the local disposal regulations.
The user is liable for all and any damage and accidents that have been caused by improper use.
t
1185 x 757 x 863 mm (width x depth x height)
1085 x 757 x 213 mm
1035 x 695 mm
circular saw bench 60 mm (guide bar 60 mm)
circular saw bench 570 mm
guide bar 740 mm
600 x 400 x 65 mm (milling table)
20 mm
117 / 92 mm (horizontal / vertical)
120 kg
24 kg
Do not use the machine for cutting firewood.
Use only hand circular saws with a maximum cutting depth of 70 mm.
Use only saw blades with a maximum diameter of 200 mm
for your hand circular saw.
Set the cutting depth of your hand circular saw before every cut in such a way
that the saw blade does not protrude more than 4 mm from the work piece.
Use only machines with a maximum output of 2760 W.
2 screw drivers: PH 1, PH 2 (not
included in the scope of delivery)
27
Use only hand circular saws with a riving knife.
1 hexagon wrench: SW 10 (not
included in the scope of delivery)