Using the System
Start Engine
When the engine is OFF, press and release the remote control
button to start the engine. If the remote start fails to turn on, the
vehicle parking lights will flash to indicate the cause. Refer to the
following table for the likely cause.
Alert Conditions:
Parking Light
Flashes*
5
6
7
9
Unlock Doors
When the engine is running with Remote Start, press and release
the re mote control button. The doors Unlock, the parking lights
flash and the horn sounds (if connected) as confirmation.
Stop Engine
When the engine is ON with Remote Start, press and hold the
remote control button until the transmit LED flashes fast. The engine
stops run ning and the parking lights turn OFF.
Car Finder
When the engine is OFF, press and hold the remote control button
for three seconds. The horn sounds (if connected) once and the
parking lights flash multiple times.
4
Possible Cause
Brake ON
Hood Open
After performing Remote Start
command MTS not enabled.
Start Valet on
Solution
Release Foot Brake.
Close Hood.
Enabled MTS Mode.
Turn Start Valet off
© 2017 Directed. All rights reserved.