Electrical Connections; Parts Identification - Dri-Eaz AirPath F377 Manual Del Propietário

3. Pick up or roll the unit using the handle and move it to the
center of the next area (12 × 12 ft. area) of carpet for
drying. NOTICE! Do not use the electrical cord to move or
position the unit. Turn the unit to the desired speed (Low – I
or High – II).
Transporting and Storing
1. Use the handle to load or carry the unit.
2. When transporting in a vehicle, secure the unit and strap it
into place to prevent sliding and possible injury to the unit
and vehicle occupants. NOTICE! Store securely to avoid
any damaging impact to the motor, blades, and other
internal parts.

ELECTRICAL CONNECTIONS

This unit is designed to operate on a 115V/60 Hz electrical
connection. Make sure that the electrical outlet is grounded
and that all safety precautions (outlined on page 1 of this
manual) are taken.
MAINTENANCE
Always turn off the power and unplug the unit before
performing maintenance procedures. WARNING! Turn off and
unplug unit before servicing or clearing obstructions.

PARTS IDENTIFICATION

High (II) / Low (I) switch
Locking
Caster
Power cord
07-01596H F377
Rotomolded
shell
Inlet grill
Handle
Locking caster (×3)
Lock washer
Flat washer
Outlet
grill
Weekly Maintenance
Keep Unit Clean: Keep outlet air vents clear of lint/dust debris
by vacuuming out as needed.
Monthly Maintenance
Clean Components:
 Using a Phillips #2 screwdriver, unscrew the four screws
connecting the bottom grill and the wire support grill
behind it. Carefully lift off bottom grill. CAUTION! Watch
for pinch points when handling grill; careless handling
could result in injury.
 Next, inspect blades for dirt, dust and debris. If dirty, wipe
down the blades with a damp cloth.
 Use a vacuum or a damp cloth to remove lint and dust
from motor and grill covers.
WARNING! Do not allow water into the motor. A buildup of
lint and dust will reduce the airflow and may cause the
motor to overheat and become a fire hazard.
Inspect Motor: Look for debris or damage to motor. Call an
Authorized Service Center for help.
Do Not Wet Motor: To prevent damage to motor, do not use a
hose or pressure washer to clean the unit. If motor becomes
wet, let motor dry before using again.
WARNING! Keep motor dry, a wet motor could result in
personal injury.
Exterior Inspection: Evaluate exterior components and make
sure they are properly installed. If you hear any abnormal
sounds when running the unit, call an Authorized Service
Center.
WARNING: This product and other substances that
may become airborne from its use contain chemicals,
including lead and phthalates, known to the State of
California to cause cancer, birth defects, or other reproductive
harm. For more information, go to P65Warnings.ca.gov
SPECIFICATIONS
Model F377
Weight 38 lbs. | 17.3 kg
Dimensions 14.7 × 25.4 × 26 in.
(H × W × D) 37.3 × 64.5 × 66 cm
Speed 2 speed switch
Amps 7.5 amps
Power 746 W (1.0 HP) / 120V / 60Hz
Cord Length 25 ft. | 7.62 m
Fan 8 Blades
Construction Rotomolded shell
Wheels Plastic
Safety ETL listed to UL and CSA standards
Specifications are subject to change without notice. Some
values may be approximate.
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR.
2 Dri-Eaz Products, Inc.