HAMPTON BAY 413-953 Manual De Instrucciones página 4

ASSEMBLY / INSTALLATION INSTRUCTIONS:
Assembly / Installation for Solar Tiki
Torch Use:
1. Push the ground stake into the ground until it
is firmly in place.
CAUTION: DO NOT use a hammer. If the
ground is too hard, soak the area with water
to soften it or drive a metal rod or screw
driver into the ground to create a hole for the
ground stake.
2. Once the ground stake is firmly in place,
assemble 3 poles with 2 coupling connectors
as shown in Figure 1.
3. Insert poles assembly over the ground stake.
4. Insert the upper end of poles assembly onto
bottom cap of lamp body.
Assembly / Installation for Solar Path
Light Use:
1. Push the ground stake into the ground until it
is firmly in place. If the ground is too hard,
soak the area with water to soften it or drive
a metal rod or screw driver into the ground to
create a hole for the ground stake.
2. Once the ground stake is firmly in place,
refer to figure 2, insert one pole only over the
ground stake.
3. Insert the upper end of pole onto bottom cap
of lamp body.
4