Clean Surge Button; Picking Up Spills - Hoover SteamVac Manual Del Propietário

Continue to squeeze trigger and slowly pull carpet
cleaner back toward you (second wet stroke).
Release trigger and slowly push carpet cleaner
forward over area just sprayed with solution (dry
stroke). Then slowly pull carpet cleaner back toward
you without squeezing trigger (dry stroke).
Overlap strokes by 1 inch to help prevent streaking.
Keep nozzle flat on floor for both forward and reverse
strokes.
3.3 To get the most effective cleaning, clean room in
sections as shown. Do not use the same cleaning
technique as with a vacuum.
For heavily soiled areas, repeat back and forth
cleaning motion.
For particularly soiled carpet or spots, use the Clean
®
Surge feature (available on select models only).
Avoid saturating carpet as noted.
It is best to alternate wet and dry strokes as described
above.
For best cleaning results and to aid in faster drying of
carpet, end with more dry strokes. (Continue using
dry strokes until little water is visible passing through
the Dirty Water Tank lid.)
Clean surGe
(Available on select models only)
The Clean Surge ® button can be used to dispense
extra solution when cleaning particularly soiled areas
of carpet or spots.
To use, press Clean Surge
solution trigger. For normal solution spray, release
button and continue to squeeze solution trigger.

piCkinG up spills

®
Your HOOVER SteamVac
be used to pick up small liquid spills (1 gallon or less,
never to exceed 1/4 inch in depth) on carpet,
upholstery, or bare floors.
For best results, pick up spills immediately by placing
the stair/upholstery nozzle (Available on select
models only) just above the spill and suction up any
residue on top of the carpet. If the spill remains, place
either the stair/ upholstery nozzle or floor nozzle with
brushes turned OFF in front of the spill, pull the
nozzle very slowly over the spill initially with suction
only. Repeat with spray and suction.
When picking up spills on bare floors, use only the
floor nozzle with the bare floor attachment (Available
on select models. Bare floor attachment sold
separately) in place and speed selector in the OFF
position (this will help prevent spreading the spill).
button
®
®
button while squeezing
®
carpet cleaner may also
3.3
Start
Exit
IMPORTANT
To avoid saturating carpet, do not use more
than 4 wet strokes over one area. Always end
with dry strokes.
If a spot is left, the stair/upholstery nozzle is generally
more effective for removing it. Although no cleaning
solution can completely remove all spots, they can
be treated by following the instructions provided by
the manufacturer of the carpet, upholstery, or bare
floor surface being cleaned.
Do not use the SteamVac
flammable or combustible liquids or chemicals.
Actual model may vary from images shown.
11
®
carpet cleaner to pick up