Tabla de contenido
Publicidad
6
6
1N
NAIL
(28 used in this step)
Carefully turn your unit over onto its front edges. Unfold the BACK (E) and lay it over your unit.
Make equal margins along all four edges of the BACK (E). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
With your hammer, gently tap four TACK GLIDES (12E) into the bottom edges of the ENDS (A and B) and LEGS (H).
414031
E
A
H
12E
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
B
12E
H
These TACK GLIDES
should be as far
forward as possible.
Page 9
Publicidad
Tabla de contenido
