Using The Chronograph - TW Steel CEO Manual Del Usuario

aDjuSTing The DaTe
Pull the crown out to the 1st position. Turn the
crown anti-clockwise to set the date. After the
date has been set, push the crown back to its
normal position.

uSing The ChrOnOgraph

The chronograph is able to measure and display the time ac-
curately to 1/20th of a second, up to a maximum of 59 minutes
and 59 seconds. The retrograde chronograph 1/20 second hand
keeps running continuously for 30 seconds after starting and then
stops at the (0) position. Press button B to change the watch to
the chronograph mode. The second hand stops at the (0) position
and changes to the chronograph 1/20 second hand.
The chronograph can be started and stopped at any time by
pressing button A.
Pressing button B resets the chronograph. All hands will then
return to their (0) position. The chronograph second hand can be
restarted by pressing button B once again.
If the chronograph second hand and the chronograph 1/20 se-
cond hand do not return to the (0) position after the chronograph
has been reset or after the battery has been replaced, you should
do the following. Pull the crown out to the 2nd position. Press but-
ton A to set the chronograph second hand to the (0) position.
Press button B to set the chronograph 1/20 second hand to the
(0) position. The chronograph second hands can be advanced
rapidly by continuously pressing button A or B. Once the hands
have returned to the (0) position, return the crown to its normal
position and screw the crown cap clockwise back to the case.
17