Advanced Functions - Airzone innobus Manual De Usuario

8. SELECTION OF THE SET POINT TEMPERATURE
In order to select the set point temperature, with the thermostat in the On position, press
several times in order to increase or reduce the temperature by intervals of 0.5ºC.
NOTE: If the Tacto thermostat is in the sleep
mode and the room temperature can be
viewed (i.e. there are no selection
arrows), press once on the set point
temperature in order to have this and the
selection arrows displayed.
9. USER SLEEP MODE
You can set the Sleep mode in each of the
system's zones. This mode is designed to
maintain the temperature more efficiently. This
mode changes the set point temperature by
0.5ºC every 30 minutes until it reaches 2ºC.
In order to activate the Sleep Mode press once
on the selection arrows until the Sleep Mode
icon (a half moon) appears.

10. ADVANCED FUNCTIONS

10.1. Door/ Window Contact
If your installation is provided with magnetic
sensors on doors and/or windows, which are
connected to the Airzone Innobus system, the
system will operate normally when these are
closed.
However, if the sensors detect a door or
window with magnetic contact is open, the
system will turn off the air-conditioning for that room and the message DOOR (DooR) will
appear on the Tacto thermostat of the relevant zone. When the door or window is closed
again, Innobus will automatically return the zone to its previous condition.
All manuals and user guides at all-guides.com
Fig. 15 - Selection of the set point temperature
Fig. 16 - Selection of the Sleep mode
Fig. 17 – Active door/ window contact
Select using
the selection
arrows
Selecting the
Sleep mode
(press once
only)
Warning:
a door/ window
is open
57