Airzone innobus Manual De Usuario página 61

As PROG1 is the one
with most priority, a
temperature of 20.0ºC is
set from 11:30 to 16:00.
11.3. Create a Programme
In order to create a new programme:
1) If the zone is not in the OFF position, turn it to OFF by
pressing once on the On/Off icon (Fig. 23).
2) Press on the AIRZONE icon once and then on the clock
icon (Fig. 24).
NOTE: If this is a main thermostat and programmes P2 are
enabled, you must select the type of programme you
wish to create, i.e. P1 or P2. In this case, the
programming mode is selected using the arrows,
and , and it is confirmed with the AIRZONE
icon (Fig. 25).
3) Select the day or group of days for which the programme
will be established. The day is selected using the arrows,
and , and it is confirmed using the AIRZONE icon
(Fig. 26).
NOTE: When you select a group of days and an
individual day within the group has a programme
already defined, this specific day will remain fixed,
that is, it will not flash.
4) Select the programme you wish to create by pressing on
PROG1, PROG2 or PROG3. Please bear in mind the
priorities established (Fig. 27).
5) Press on the ON/OFF icon to start setting up the selected
programme (Fig. 27).
6) Select the hour of the start time using the selection
arrows and confirm it by pressing once on the AIRZONE
icon once (Fig. 28).
7) Select the minutes of the start time using the selection
arrows and confirm it by pressing once on the AIRZONE
icon (Fig. 28).
8) Select as appropriate depending on whether the set up is
for an air-conditioning mode programme (P2) or a set
point temperature programme (P1) and then confirm by
pressing once on the AIRZONE icon (Fig. 29). While the
selection arrows are used to select the temperature, the
area of the required mode needs to be pressed in order
to select the air-conditioning mode and the selected
All manuals and user guides at all-guides.com
Fig. 23 - Press ON/OFF icon
Fig. 24 - Press on the Airzone
icon
Fig. 25 - Select the type of
programme at the Master Tacto
thermostat
Fig. 26 - Select a group of days
Fig. 27 - Select the programme to
set up
61