8.2.1 Setting of the wind alarm threshold
For all HELIOS PROX control units, the above – named safety threshold of the velocity of the wind is set at value of 0 Km/h.
This velocity can be changed from 0 to 60 Km/h acting on the adjusting device (trimmer) present on the card, as represented on the picture be-
low:
Increase of the safety threshold
0 Km/h
ATTENTION: the condition "open sunshade" is satisfied only in the case in which no alarm is present. The presence of an alarm would
immediately close the sunshade and would block every type of external control for 7 minutes; in this way the sunshade would rest
closed, waiting for the output from this state.
ATTENTION: during the installation, to avoid waiting the 7 minutes of the alarm anytime one of the security sensors would intervene,
it is possible to reset the normal functioning of the control unit pressing the little learning key once the sunshade is completely
closed.
8.2.2 Automatic reopening
Acting on the dip – switch 1, once closed the sunshade cause of the alarm condition "presence of strong wind" detected by the
anemometer or "presence of water" detected by the rain sensor and passed the 7 minutes from the last detection above the safety
threshold, it is possible to select:
•
if you want that the sunshade is automatically reopened to the coming back of the normal conditions (position ON)
•
if it must remain closed waiting for an order coming from the mechanical buttons or from transmitter (position OFF).
ATTENTION: with dip – switch 1 on , the control unit brings back the sunshade on the position that it had before the alarm.
ATTENTION: in presence of the light sensor, the control given by it has the priority on the state of the dip – switch 1. So, if the
dip – switch 1 is on OFF and there is intense light (over the opening threshold), the sunshade will be reopened.
8.2.3 Step by step/ dead man functioning
ATTENTION: THIS SELECTION OF FUNCTIONING IS VALID ONLY AND EXCLUSIVELY FOR THE CONTROLS GIVEN BY
MECHANICAL BUTTONS AND NOT FROM RADIOTRANSMITTERS.
Acting on dip – switch 2, represented on the picture nearby and present on the electronic card, it is possible to choose:
•
if you desire that the sunshade is totally open (close) with the simple pressure of the opening (closing) button ( position ON).
•
if you prefer that the opening (closing) is directly connected to the pressure of the relative button, so stopping at its release
(position OFF).
8.2.4 Setting of the light threshold
Acting on the jumper it is possible to choose the light threshold of automatic opening/closing of the sunshade. The green led present on the card
allows to understand the level of light received by the sensor. Green led turned off, level of light under the closing threshold, it means that the
sunshade would automatically close for absence of light.
Green led blinks slowly, the level of light finds itself between the opening threshold and closing threshold, so the sunshade maintains its position.
Green led blinks rapidly, the level of light finds itself above of the opening threshold, it means that the sunshade will automatically open only if it
finds itself on close position. If it finds itself on any intermediate position it does not open because it is supposed that this position has been
manually reached.
Light threshold 1
1.
Light threshold 1: with this setting of the light threshold, the sunshade will automatically open and close with little luminous intensity. This
means that the sunshade will open early in the morning and close late in the evening.
2.
Light threshold 2 : with this setting of the light threshold the sunshade will automatically open with a luminous intensity higher than the
threshold nr.1, that corresponds to a more late opening of the sunshade and automatically close with little luminous intensity, the same
that this of the threshold nr.1; it means that the sunshade will close itself late in the evening.
3.
Light threshold nr. 3: with this setting of the light threshold, the sunshade will automatically open and close with a luminous intensity
higher than this of threshold nr. 1. It means that the sunshade will open late in the morning and close early in the evening.
6-1621095
rev.9
19-07-2012
~30 Km/h
60 Km/h
Light threshold 2
ITA
ENG
Decrease of the safety threshold
~30 Km/h
0 Km/h
Light threshold 3
FRA
ESP
DEU
POR
60 Km/h
O
1
2
N
O
1
2
N
Reserved
13 / 32