Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
.
Select the torque tester with which the calibration will be performed:
- COD.57650 Torque tester SQ 1/2''_____35-350 Nm (POSITION 1).
- COD.57652 Torque tester HEX. 27mm__200-2000 Nm (POSITION 2).
2
.
Open the safety cover to proceed with the installation of the torque wrench.
Make sure the torque tester is on when calibrating.
3
.
Place the torque wrench in the position of the torque tester you will be using. The use of
an adapter may be required to connect the square drive of the torque wrench to the tester.
Place the torque wrench in POS. 1 to use the 57650 torque tester.
Place the torque wrench in POS. 2 to use the 57652 torque tester.
4
.
The torque wrench must be placed in a horizontal position.
Then slide the pusher horizontally so that it is located between the rear part and the handle
of the wrench. It will always be placed at the height of the middle of the handle, which is
where the application point is located to achieve the required torque.
Close the safety cap.
5
.
Make sure the torque tester to be used is turned on.
6
.
As you start turning the crank to the right, load the key. The rotation must be continuous
until the torque wrench reaches the selected torque. At that time the torque value on the
tester will be fixed.
After the test is complete, make a note of the test torque value indicated on the torque
tester display.
Turn the crank counterclockwise until the torque wrench is in the free (no load) position.
7
.
In case of CCW calibration, place the tool fig.11 in torque wrench housing at required
position and follow previous procedure for calibration.
12
QUICK USE GUIDE
Before starting the calibration:
-
the torque wrench must not be loaded.
-
the right end of the torque wrench housing must be at the rear
end of the spindle.
For information on torque testers,
see the instruction manuals at www.egamaster.com
Publicidad
Tabla de contenido
