Basic Safety Instructions - Ega Master 79666 Manual De Instrucciones

Metal cutting
When cutting angle iron, H•beam, I•beam, tubes, pipes etc., start the cut on the surface
where the greatest number of teeth will contact the work.
Useful tips: Select thoroughly the length of the saw blade (see fig. 8 and 9). (Length of blade
(free hand cutting) = max. section + 30 mm.)
Procedure for handheld cutting
For straight or curved cutting, place the support shoe on the work piece and start the saw.
Use only sharp and faultless blades. Take care to cut at a uniform feeding speed. This will
reduce the risk of accidents and wear on blade and saw. Always keep the connecting line (air
hose) towards the rear of the saw.
After finishing the sawing work
• Shut valve.
• Shut compressed air supply and disconnect air hose.
• Clean saw.
• Inspect machine for damages.
Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow the instructions
during operation.
Do not modify the machine or the machine tools and accessories after receipt. Any
constructive changes or modifications need the manufacturer`s acceptance and have to be in
compliance with the safety instructions. Use the machine only for its determination. Consider
the technical data of the equipment and the ambient temperatures. Pay attention to labels,
restrictions of use and special instruction notes on the machine tools and the machine itself.
Check regularly that the type plate and symbols on the machine are legible. If necessary,
contact the manufacturer to replace them. Only operators with technical knowledge, trained by
authorized responsible technical personnel, may install, adjust, operate, transport and store the
machine.
Fig. 8

BASIC SAFETY INSTRUCTIONS

Fig. 9
39