Inepro PayMatic AD2400 Manual De Instrucciones página 16

Settings
Function FB, Running time counter (reset possible)
The running time counter is an electronic counter, which registers cumulatively the number of minutes
the main channel, relay 1, has been operative. The main channel relay 1 is only active during the main
®
time of the PayMatic . It is possible to scroll the counters by pressing the up key. The 6-digit counter is
read back to front, as follows;
first counter 1 =
second counter 2 =
third counter 3 =
forth counter 4 =
fifth counter 5 =
sixth counter 6 =
In this example the total running time amounts to 005731 minutes
Resetting the counters
After reading the counters, these can be reset. The reset-procedure is as follows;
1, After having read the count (6X) press the up and the down keys simultaneously
- -- (2 hyphens) will appear on the display
2, To reset the counter press the up key,
- "CL" will appear on the display
3, Now press the up and the down keys simultaneously
- the counters are reset and the PayMatic
Note: if necessary, you can also read out the indication on the counter without resetting it during the
stand-by period, to do so, press the down key during 3 seconds. The indication of the counters of
Function FB will be represented automatically, but cannot be reset.
Function FC, Coin counter (reset possible)
Reading and reset procedure as in function FB. This counter reproduces the number of coins.
Function FD, Running time counter (reset impossible)
Reading as in Function FB but this counter can not be reset.
Function FE, Coin counter (reset impossible)
Reading as in Function FB but this counter can not be reset. This counter reproduces the number of
coins.
Function FF, TAT (Automatic main time adjustment)
Activating this function, the main time is automatically adjusted on the basis of the service counter
progression (F6 & F7). If one of the two service counters is programmed again the TAT function has to
be preset again as well.
Setting "00": TAT function off
Setting "01": TAT function on
Running hours Prolongation per minute Running hours
0 – 49 + 0 sec p/m
50 – 99 + 3 sec p/m
100 – 149 + 5 sec p/m
150 – 199 + 8 sec p/m
200 – 249 + 11 sec p/m
250 – 299 + 14 sec p/m
300 – 349 + 16 sec p/m
350 – 399 + 19 sec p/m
400 – 449 + 22 sec p/m
value "1",
1 1
value "3",
2 3
value "7",
3 7
value "5",
5
4
value "0",
5 0
value 6 0 "0",
®
will automatically resume its function.
(ECOS module EM-10)
450 – 499
500 – 549
550 – 599
600 – 649
650 – 699
700 – 749
750 – 799
800 – 849
850 - 899
®
PayMatic AD2400(-B) Version 2.0 5-11-2007
- www.inepro.com
(ECOS module EM-10)
(ECOS module EM-12)
(ECOS module EM-12)
(ECOS module EM-11)
Prolongation per minute
+ 24 sec p/m
+ 27 sec p/m
+ 30 sec p/m
+ 30 sec p/m
+ 30 sec p/m
+ 30 sec p/m
+ 30 sec p/m
+ 30 sec p/m
+ 30 sec p/m
-
16