Essick Air Bemis 527 300 Manual Por El Propietario página 3

CAUTION-We recommend using Bemis by Essick Air Bacteria Treatment when
ever you refill the water bottles to eliminate bacteria growth. Follow the direc-
tions to determine the proper amount to be added to the 3 gallon reservoir.
The wick does not require the use of chelating agent type water treatments
that are intended for use in Rotobelt or Water Wheel type humidifiers.
Locate your humidifier on an inside wall, near an electrical outlet. The
humidifier should be at least 4" away from the wall for best results. Do not
position the unit directly in front of a hot air duct or radiator.
Assembly, Filling & Operation
ASSEMBLY:
1) Unpack humidifier from carton.
2) Remove all packaging
material, wicks, etc. from cabinet.
3) The wicks are located by four
pairs of ribs in the bottom of
the cabinet. Locate the two
wicks. Insert them by dropping each one down into the locating ribs
(see illustration).
4) After inserting the wicks, place the transition molding on top of them,
flange side up. The notch along one side of the transition goes to the
back of the cabinet.
5) Place the chassis unit into the cabinet, with the switch to the back and
hang it onto the mounts at the front and back inside of the cabinet.
FILLING:
6) Before replacing the top grille, fill the reservoir with cool, fresh, preferably
unsoftened water . DO NOT POUR WATER OVER THE ELECTRICAL
CHASSIS. Fill the cabinet only through the opening between the left
wick and the cabinet sidewall, to the level marked "Fill to Here" on
the left side rear wall of the cabinet. If water spills on the chassis, it must
Clean, Space Saver moisturizing.
Dry air is drawn into the unit and
washed with water as it passes
through the moistened wick and
out into the room to provide a
comfortable spring fresh moistened
atmosphere.