Ega Master MASTEREX 77780 Manual De Instrucciones página 6

ENGLISH
• Please read this instruction before any use, maintenance and service of explosion-proof lights.
• The explosion-proof light must be used by a certain professional training person.
• Must use the replacement parts which produced or appointed by the manufacturer for
maintenance.
Make sure the maintenance and service are not in a dangerous place and fulfilled by
professional trained person. Using the parts which not manufactured by the manufacturer will
destroy the explosion-proof performance of the explosion-proof lights.
• The explosion-proof lights should comply with the relevant laws and regulations of the
European Union.
WARNING!
• Do not open when an explosive atmosphere is present!
• Do not charge the battery in hazardouslocation!
• Do not replace battery when anexplosive atmosphere is present!
WARNING!
Battery Pack:
• Only use the battery pack from the manufacturer.
• Only use the charger pack with spec of Input: AC100-240V/50-60Hz 0.8A Output: 25.2V 1.5A
• Using other sources parts may lower the intrinsic safety level of the explosion-proof lights.
Make sure charging in non-dangerous environment.
IEC 60079-0:2017 Explosive atmospheres, Par0:Equipment, General requirements
IEC 60079-1:2014 Explosive atmospheres, Par1:Equipment protection by flameproof
enclosures "d"
IEC 60079-7:2015 Explosive atmospheres, Par7:Equipment protection by increased safety "e"
IEC 60079-18:2014 Explosive atmospheres, Par18:Equipment protection by type of protection
"m"
IEC 60079-11:2012 Explosive atmospheres, Par11:Equipment protection by intrinsic safety "i"
IEC60079-28:2014 Explosive atmospheres, Par28:protection of equipment and transmission
systems using optical radiation
IEC60079-31:2013 Explosive atmospheres, Par31: Equipment dust ignition protection by
enclosure"t"
IEC 60529:2001 Degrees of protection provided by enclosure (IP code).
6
IMPORTANT REMINDERS
1. STANDARD