Installation - Lamborghini Caloreclima ECO 15 Manual Para La Instalación Y El Mantenimiento

INSTALLATION

POSITIONING THE BURNER
We recommend that you fit the burner on the boiler in the position indicated in figures A and B. Do not
assemble in positions C or D otherwise the anti-drip device in the nozzle holder cannot be used. Above all,
positioning here allows good regulation of the air intake gate and allows its immediate closure when the
burner is switched off. Fit the burner in positions C or D only if absolutely necessary.
FITTING THE BURNER ON THE BOILER
After preparing the boiler front according to the dimensions of the attachment template (see Fig. 2) it is
necessary to fix the burner coupling plate (8) with the two lower screws: make sure you interpose the
supplied insulation gasket. Fit the burner on the coupling plate and position it as indicated in Fig. 11 (items
A and B).
IMPORTANT: if the burner is installed in position B the nozzle holder must be rotated 60° so that the notch
on the holder (see fig. 8-13) is facing upwards. Then lock the burner in place with the screw (39) and fix the
attachment plate with the two upper screws.
BEFORE STARTING THE BURNER ALWAYS CHECK THE FOLLOWING:
- Burner and control unit have a proper earth connection.
- The on-burner nozzle (3) has a flow-rate suitable for the boiler.
- The nozzle holder (10) is fitted with the "O" marking facing upwards (see fig. 8-13)
- That there is fuel in the tank and the gates are open.
- The fuse on the electrical circuit is rated 3A.
- The room and boiler thermostats are set to the desired temperature.
- The switch on any room thermostat is set to ON.
- The main switch contacts are open.
- Any other control device has contacts closed.
- The air adjustment screw allows the throttle valve to open.
37
Fig. 11