Aquaglide CHELAN 155 Manual Del Usuario página 6

ASSEMBLY
Inflatable Products – Aquaglide makes some of the highest quality inflatable products in the world.
With proper care and maintenance, our products are expected to last for years under normal use. We list
important tips and instructions below. If unsure about any point, please reach us through our website at
Aquaglide.com/contact-us.
Air Pump - Use an air pump recommended for inflating your product; a high-volume hand pump is
common. Other frequently used options are high-volume electrical pumps operating on either 12v (car
battery) or AC mains power (120v or 230v) depending on available power sources. Air compressors
designed for high-pressure inflation are not recommended because they can easily lead to over-inflation.
Valve(s) – This product uses Halkey Roberts – type (HR) and Twist-Lock valves. HR valve attaches to
product using a threaded backing plate, making it easily replaceable in the
unlikely event of damage. Access valve by twisting cap counterclockwise.
A
Pull to remove – cap is attached to valve by lanyard. To close, place cap over
valve, twist clockwise to secure. Note: cap is the secondary air seal. See A.
To inflate, an air pump with Halkey Roberts – type (HR) valve fitting is required.
Insert fitting firmly into valve and twist clockwise to lock in place. See B.
Valve Operation: To operate Halkey Roberts – type
B
(HR) valve, press plunger and turn 90 degrees to set
valve for inflate and use (plunger out = 1-way airflow).
Press plunger and turn 90 degrees to deflate (plunger
in = 2-way airflow). Note: valve is primary air seal. After
inflation, close with cap for secondary seal. See C.
Seats use Twist-Lock valves for easy inflation and
control. To open, locate hose-end fitting valve and twist
C
counterclockwise. Inflate using pump with Boston or HR
fitting (over valve), or Stem fitting (into valve). Close by
twisting blue hose-end fitting clockwise. See D.
Universal Mount Plate: Product is fitted with Universal
Mount plate(s) designed to fit a wide range of aftermarket
Inflate (1-way) Deflate (2-way)
accessories including AG Cupholder, sold separately. See
D
Aquaglide.com FAQ for a list of useful accessories. Plate
accepts ¼-20 x 7/8" Stainless mounting screws. Internal hardware is #304
grade Stainless and should be thoroughly rinsed with fresh water after ocean
use. See E.
Molle Plate: Product is fitted with molle plates [pronounced Molly - Modular
E
Lightweight Load-carrying Equipment] designed to fit a wide range of
aftermarket accessories including AG Cupholder, sold separately. Plate
accepts standard molle/ pals accessories with 1" (25mm) webbing ladder.
One mesh pouch is included for each molle plate. To install, push plastic
spring-snaps downward through outermost molle loops, then adjust rope
tension to suit needs. See F.
Proper Working Pressure for each chamber is listed below. Do not overfill or
underfill. Excessive pressure can cause damage to the product and may void
the warranty. Do not use without adequate air pressure. Product can become
unstable if underfilled and may not support indicated capacity. Use a pressure
gauge (manometer) to carefully monitor air pressure in the
product especially during hot or cool periods.
F
6 www.aquaglide.com