Optional Floor Stand Installation - Empire SR-6-3 Instrucciones De Instalación Y Manual Del Propietario

OPTIONAL FLOOR STAND INSTALLATION

1. Align clearance holes on floor stand with screw holes on
bottom of heater, as shown in Figure 14.
2. Attach floor stand to heater with (4) screws provided with floor
stand.
3. Connect the gas line.
*Floor stand can not be used in a bathroom or bedroom
installation. SR-6 must be wall mounted in a bathroom or bedroom
installation.
*Floor stand can not be used in a bedroom installation. SR-10
must be wall mounted in a bedroom installation.
Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other
combustible material, other than wood flooring, the appliance
shall be installed on a metal or wood panel extending the full
width and depth of the appliance.
Attention: Optional Floor Stand meets requirement.
The base referred to above does not mean the fire-proof base as
used on wood stoves. The protection is for rugs that are extremely
thick and light colored tile.
Page 12
SR-30 Shown
Figure 14
16942-3-0506