Crafter's Companion Gemini JUNIOR Guia Del Usuario página 7

EMBOSSING WITH CRAFTER'S COMPANION™ DIES
Recommended Combination: Clear Cutting Plate on the bottom, then the Plastic
Shim, Die, Material to be embossed, Rubber Embossing Mat, and
Clear Cutting Plate on top.
• Start with the Clear Cutting Plate on the bottom.
• Place the Plastic Shim on top of it.
• Position the cutting die, blade side up, with the smooth side facing the Plastic
Shim.
• Place your Material on top of the die. Important: If you have just cut the
die your Material will still be inside the die – do not remove it. Remove the
Magnetic Shim and/or the Metal Cutting Plate, and continue as follows with
your die in place:
• Place the Rubber Embossing Mat on top of the Material.
• Place the Clear Cutting Plate on top of the Rubber Embossing Mat.
• Align the platform combination and feed it into the Gemini Jr.™.
• Release your hold on the platform combination once the motor begins to pull it
into the machine.
EMBOSSING WITH 2D FOLDERS
Recommended Combination: Clear Cutting Plate on the bottom, then the Embossing
Folder with the Material inside, and Clear Cutting Plate on top.
• Place the Material to be embossed inside the embossing folder.
• Place the embossing folder between the Clear plates.
• Align the platform combination and feed it into the Gemini™.
• Release your hold on the platform combination once the motor begins to pull it
into the machine.
NOTE: If you are embossing very thin material (such as vellum or acetate), you can
decrease the pressure by placing a piece of thin copy paper inside the embossing folder.
Clear Cutting Plate
Rubber Embossing Mat
Material to be embossed
Die (blade side up)
Plastic Shim
Clear Cutting Plate
Clear Cutting Plate
2D Embossing Folder with
Material inside
Clear Cutting Plate
Pg.5 | ENG-5