Crafter's Companion Gemini JUNIOR Guia Del Usuario página 8

EMBOSSING WITH 3D FOLDERS
Recommended Combination: Clear Cutting Plate on the bottom, then the Magnetic
Shim, the 3D Embossing Folder with the Material inside, and then the Plastic Shim on
top.
• Place the Material to be embossed inside the 3D embossing folder.
• Place the embossing folder between the Magnetic Shim and the Plastic Shim,
with the Clear Cutting Plate on the bottom.
• Align the platform combination and feed it into the Gemini Jr.™.
• Release your hold on the platform combination once the motor begins to pull it
into the machine.
TROUBLE SHOOTING
No Power: If the Gemini Jr.™ does not turn on, check that the plug is inserted
completely into the back of the machine, and that the plug is fully inserted into the
wall socket. Check that the wall socket is live by plugging in another device. Also
check that main power switch on the back of the unit is turned on.
The Gemini Jr.™ Stops and Reverses: Verify the platform combination before feeding
it into the machine again. Check that the plates are aligned correctly and that no
material is protruding or touching the inside of the machine. Also check
that you are not trying to cut or emboss too many layers of material
at one time.
The Gemini Jr.™ stops after 60 minutes of continuous use: The Gemini Jr.™ is
equipped with a heat sensor to protect the motor. Allow the unit to cool down for 25
minutes before resuming operation.
Shallow Emboss or Cut: Verify that your folder or die is not damaged. Add a shim on
top of the Clear Cutting Plate to increase pressure.
GENERAL CARE AND SAFETY WARNINGS
• To clean, wipe the exterior with a soft, dry cloth. Do not use abrasive cleaners
or rough surface sponges.
• This product is intended for children aged 14+ and should not be used by
younger children without adult supervision.
• Keep hands away from plates and other parts in motion.
• Be aware that loose fitting clothing can get caught between plates and be
pulled into the machine.
• Do not disable the safety sensors and override the motor controls.
Pg.6 | ENG-6
Plastic Shim
3D Embossing Folder with
Material inside
Magnetic Shim
Clear Cutting Plate