Adler europe AD 7957 Manual De Uso página 4

15. Do not immerse the motor unit in water. Do not handle the appliance or power cord with
wet hands.
16. For household use only.
DESCRIPTION OF THE DEVICE (fig A)
1. Water mist outlet
CONTROL PANEL (diagram B)
1. „ON/OFF/SLEEP" button
Switching
Fill the tank with water and then place on an even and dry surface. Turn it on with the "ON / OFF / SLEEP" button. The appliance will turn
on, the blue operation indicator will light up on the control panel and the steam will escape from the device. At the very beginning of
the operation, the level of atomisation may seem unstable, which results from the difference in temperature and water quality. This
process will stabilize in a short time.
Adjusting the intensity of the steam outflow:
You can adjust the intensity of the mist by pressing the "MIST" button (1/2/3)
Timer
To set the timer, press the "TIMER" button on the control panel to set the working time 1/2/3/4/5/6/7/8 hours.
Humidity
By pressing the "Humidity" button you can set the desired humidity level in%. A relative humidity of 40 to 60% is recommended. The
accuracy of the measurements is +/- 5%. The device will turn off when the humidity level exceeds the desired setting. The target
value is displayed during selection. The display will automatically show the current value after a few seconds.
Sleep
To activate the SLEEP mode, press the «SLEEP» button on the control panel for 3-5 seconds, after which the display will turn off
completely. To deactivate this mode, press the «SLEEP» button on the control panel again for 3-5 seconds, after the SLEEP
indicator on the display will turn off and the LED display will light up.
Automatic shut-off in the event of lack of water When the water level in the tank drops below the minimum allowed, the ultrasonic
diaphragm of the device will automatically turn off and the water-low indicator will light on the control panel. To continue the
operation, it is necessary to fill the tank with water.
Filling the tank
Always disconnect the appliance from the power supply before removing the water tank. Do not touch the water in the base while
working.
● Remove the water tank from the base and unscrew the water tank cap.
● Make sure that there are no foreign objects in the tank.
● Fill the tank with clean cold tap water. Carefully close the water tank cap, place the water tank on the base.
● Do not pour water into the device's mist outlet.
● Insert the plug into the socket and turn the device on using the ON / OFF knob.
Application of additives
You can use water additives (essential oil, fragrances). Into the water tank.
Cleaning / maintenance
Always disconnect the device from the mains before removing the water tank. Do not touch the water in the base while working!
Caution - risk of electric shock and product damage.
● Before cleaning, switch off the device and unplug it.
● Regularly clean the water tank and the base. Use only water, no detergents.
Storing the device for a long time
Clean the device as described previously and let it dry completely. It is best to store the device in the original packaging, in a dry place,
away from high temperatures.
Technical Data:
Voltage: 230V ~ 50Hz
Nominal Power: 23W
Max Power: 25W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
2. Water tank 3. Base
2. MIST button 3.Timer Button
DEUTSCH
4. Control panel
4. Humidity Button
4