Control Settings; Interior Light - GE GWS0 Manual Del Propietario Y Instalación

About the control and settings.

Control Settings

The temperature range of the wine center/beverage
and wine center is intended for 41°F (5°C) to
61°F (16,1°C). The display shows the average
temperature of the appliance. It is normal for
the actual temperature to vary slightly during
operation.
Auto Temperature Setting
When the appliance is plugged in or the "+" pad
is pressed, the appliance runs on the "Auto Bev"
setting of 44°F (6,7°C) and the "Auto Bev" indicator
light in the upper left corner stays lit.
NOTE: Display will flash when the "+" pad is
pressed.
Normal Temperature Setting
The temperature of the appliance can be set
anywhere between 41°F (5°C) to 61°F (16,1°C) by the
"+" and "–" pads.
Press and hold the SET pad. You will hear a
series of 2 beeps.
After the second beep, press the "+" and "–"
pads to increase or decrease the desired
temperature in increments of one degree.
When the Wine Center/Beverage and Wine Center is Plugged In
After plugging in the wine center/beverage and
wine center and setting the desired temperature,
allow the appliance to reach the set temperature
before loading your wine. The temperature may
take up to 12 hours to completely stabilize.
After loading the wine and/or beverages, you may
notice the actual temperature rise. This is normal.
The actual temperature will continue to change
as the wine and/or beverages are cooled to the
set temperature. The temperature may take up to
12 hours to completely stabilize.

Interior Light

You can turn the light ON or OFF by pushing the
light switch located on the right side of the control
panel housing. If the interior light is left on, it will
raise the inside temperature.
6
Auto Bev
Indicator Light
During this time the display will flash.
Press SET to confirm your choice. The display
will stop flashing. If no confirmation is made in
ten seconds, the unit will automatically accept
your change.
NOTE: When you change the temperature setting,
there may be a 5-minute delay until the compressor
starts to run.
Fahrenheit and Celsius
The temperature display can be changed between
Fahrenheit and Celsius by pressing and holding the
"+" pad for approximately 5 seconds.
Indicator Light
The indicator is lit when the compressor is
running to cool your unit. It will not be lit when the
compressor is idle.
Interior Light
To switch the interior light on/off, simply press the
pad.
A guide with wine serving
temperature suggestions
is located on the inside
right portion of the unit.
It gives recommended
temperatures for
different wines, as well as
instructions on adjusting
the temperature of the
wine center/beverage and
wine center
NOTE: The exterior of the
cabinet may get warm.
This is normal.