Basic Procedure; Replacing The Remote Control Batteries; Emergency Mode - Springer RQ Serie Manual Del Usuario E Instalación

BASIC PROCEDURE

EMERGENCY MODE

This mode shoud only be used to activate the equipment in case of dead batteries
on the remote control or loss or damage of the remote control.
(A)
On both cases, the equipmente will assume 23 ºC (73F) as the convenient tempera-
ture. By pressing the button once again, the equipmente will turn off.
REMOTE CONTROL POSITIONING
• The remote control can be used at a maximum distance of 7 meters from the
equipment.
• Getting sounds:
The "BEEP" will be heard in the following cases, indicating that a command was
accepted:
- on turning on
- on turning off
- on switching modes
- on changing the temperature setting

REPLACING THE REMOTE CONTROL BATTERIES

The remote control of you ELECTRONIC AIR CONDITIONING
uses two AA 1,5 V batteries. Never use old batteries or any type
other than the specified one and keep in mind that the average lasting
time of a battery is 1 (one) year. Do not replace batteries while the
equipment is on. Remove the cover of the battery chamber on the
upper part of the remote control and replace them. Test them by
turning off the equipment. If it doesn't work, remove the batteries and
repeat the operation.
The EMERGENCY MODE is actvated by an inside button
on the electronic panel, as shown on the left. Use a pointed object
to activate the button (A).
By pressing the button once, the equipment will operate on:
COOLING on cooling-only units
AUTO: on units that operate both on cooling heating
14