Basic Procedure; Replacing The Remote Control Batteries; Emergency Mode - Springer BC-127 Manual Del Usuario E Instalación

All manuals and user guides at all-guides.com

BASIC PROCEDURE

uses two AA 1,5 V batteries. Never use old batteries or any type
other than the specified one and keep in mind that the average lasting
time of a battery is 1 (one) year. Do not replace batteries while the
equipment is on. Remove the cover of the battery chamber on the
upper part of the remote control and replace them. Test them by
turning off the equipment. If it doesn't work, remove the batteries and
repeat the operation.

EMERGENCY MODE

This mode should only be used to activate the equipment in case of dead batteries on
the remote control or loss or damage of the remote control.
on the electronic panel, as shown on the left. Use a pointed object
to activate the button.
On both cases, the equipment will assume 23
ture. By pressing the button once again, the equipment will turn off.
REMOTE CONTROL POSITIONING
• The remote control can be used at a maximum distance of 7 meters from the
equipment.
• Getting sounds:
The "BEEP" will be heard in the following cases, indicating that a command was
accepted:
- on turning on
- on turning off
- on switching modes
- on changing the temperature setting

REPLACING THE REMOTE CONTROL BATTERIES

The remote control of you ELECTRONIC AIR CONDITIONING
The EMERGENCY MODE is activated by an inside button
By pressing the button once, the equipment will operate on:
COOLING: on cooling-only units.
AUTO: on units that operate both on cooling heating.
O
C (73F) as the convenient tempera-
15