Display; Safety Instructions; Assembly - Hobby ClimaControl Instrucciones De Uso

1.2 Display

= Clock symbol, fl ashes when entering the settings for time of day
= Time digits, indicate the time and are used for setting program times
= Alert symbol, fl ashes in the event of an alert
= Symbol for humidity control range
= Numerical display for temperature/humidity
= Symbol for temperature control range
= Symbol for time control range
= Symbol for humidity
= Symbol for programming desired values
= Symbol for heating mode
= Symbol for cooling mode
= Degree Celsius, unit for temperature control
= Relative humidity, unit for humidity control

1.3 Safety instructions

ClimaControl is only designed for use in enclosed rooms. All electronic components of the ClimaControl unit must
only be operated whilst they are free from defects. Should the mains supply be damaged, please call in a qualifi ed
specialist to replace it or send the device away to be repaired. Continued operation of the device may cause fatal
injury due to electric shock. Ensure that the control unit (
with water.
Technical products must only be operated as supplied. Electronic components must not be modifi ed in any way, and
the leads must not be shortened. Covers or housings must not be opened. The product must not be used if damaged
or must be shut down immediately by pulling the mains plug if damage is detected.

1.4 Assembly

Control unit
The rear side of the control unit (
fi xed to the wall or the terrarium cabinet with the screw set (
USB connector so that holes of control unit dimensions do not need to be sawn out of the terrarium cabinet. The USB
connector is not designed for a computer connection. The control unit has a cable length of 2 metres which permits
installation outside the terrarium cabinet as well as an unobstructed view of all values and status modes.
Connection strip
The connection strip (
there is no contact with the unit in the event of water leaking from the terrarium.
4
) is equipped with recesses that are used to lock the fastening rail (
) should be screwed to the back or side panel inside the terrarium cabinet to ensure that
) and connection strip (
). The cable to the control unit is equipped with a
) cannot come into contact
) which is