How To Use - Black+Decker FP1336 Manual Del Usuario

How to Use

This product is for household use only.
• Before first use, unpack the product and remove packing material. Handle sharp chopping blade
and slice/shred disc carefully.
• Wash all parts except base.
Note: Do not attempt to chop ice in this food processor; it will damage container and dull chopping
blade. This unit will not whip cream, beat egg whites to
a desirable volume, grind coffee beans or spices with a high oil content,
or slice or shred hard-cooked eggs, marshmallows, or soft cheeses.
CONTROLS
HI (ALTO) or LO (BAJO)—When these buttons are pressed, unit runs continuously until
OFF button is pressed.
OFF (APAGATO)—Processor should always be left in OFF (APAGATO) position when unit
is not in use.
PULSE (PULSO)—PULSE (PULSO) position must be pressed and held for unit to operate. When
released, unit will stop. Use PULSE (PULSO) for short processing tasks, such as chopping nuts, raw
meats, or vegetables. This lets you check processed results and control the fineness.
Important: For your protection, this unit has an Interlock system. The processor won't
operate unless container is properly locked onto base (see illustration on the base). The
tab on cover must be correctly locked into the slot on base. Be sure cover is turned fully
into slot toward LOCK/
unit without container and cover correctly locked in place. Be sure base is on a flat,
dry, clean surface before you begin processing.
A
B
7. After processing food, press the control to OFF (APAGATO) or release PULSE (PULSO) control.
Allow disc to stop rotating. Twist food chute/cover toward UNLOCK/
8. Carefully pull slice/shred disc and discharge disc if used, off the stem, remove stem, unlock container
by turning it away from its base, and lift container off.
until you hear it click into place. Do not attempt to operate
TO SLICE OR SHRED
1. Place container over center post in base with handle at left. Turn
container towards base until it drops down into place. Snap container in
towards base and be sure the locking tab locks into place (A).
2. Place disc stem onto center post in container (B) and slip the continuous
flow discharge disc onto the stem. To process directly into included
container, place the disc stem onto the center post in the container, then
grasp the slice/shred disc by its hub with the (slice or shred) up and push
it down onto the disc stem. Place food cover onto container so that its tab
is facing down towards base. Twist food cover in toward base to LOCK/
until you hear it click into place.
3. Plug cord into an electrical outlet.
4. Fill food chute with food and position the pusher over food.
5. Select HI (ALTO) or LO (BAJO)speed, then press down lightly but firmly
on food pusher. For PULSE (PULSO) control push
the PULSE (PULSO) button.
6. Note: Let processor do the work. Heavy pressure will not speed up
operation
to remove.
10