Tool it NBT 200 Manual De Uso página 7

Translation of the original instructions
1. Press «ENTER» to proceed to the load system test. The display shows «CHar». Press «ENTER» to display the voltage.
2. Make sure to keep the car consumers (air conditioning, radio etc...) switched off.
3. Run the engine between 1200 and 1500 rpm.
• Load system test result (without consumers)
Result
Green LED
Yellow LED
Red LED
4. Continue the test by pressing «ENTER». The tester returns to the main menu.
5. Turn on the heater, headlights, etc. Do not switch on cyclic loads (air conditioning and windshield wipers).
6. To test the charging system with the accessories, press «SYST» again and repeat the above procedure.
• Charge system test result (with consumables)
Examples
Green LED
Yellow LED
The red ones
DISPLAY SCREEN CASE
Examples
The display shows HI
The display shows Lo
The screen is blank
"The screen flashes or displays
« ----»"
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
NBT 200
No problem detected. Normal operation of the alternator.
The alternator does not provide enough power to the battery. Check the alter-
nator belts, and make sure the alternator is running when the engine is running.
If the belts slip or are broken, replace them and re-test. Check the connection
between the alternator and the battery. If the connection is bad, clean or replace
the cable and re-test. If the alternator belts and connection are in good condi-
tion, replace the alternator.
Check that the connections are good. If everything is properly connected, re-
place the alternator.
Analysis
Good charging system
Check connections, cables and alternator
Problem with the charging system, Check the alternator.
The battery voltage is too high for the tester.
The battery voltage is too low for the tester. Recharge the battery and repeat the
test.
The battery voltage is too low for the tester. Recharge the battery and repeat the
test. If the display remains the same, replace the battery.
The voltage is not stable. Charge the battery, then retest it. If the display remains
the same, replace the battery.
Analysis
Analysis
EN
7