Unforeseen Events - Solution Of Problems - GNATUS BIO Pack Manual Del Propietário

UNFORESEEN EVENTS – SOLUTION OF PROBLEMS
Upon coming across any problem in operation, follow the instructions below to check
and repair the problem, and/or get in touch with your representative.
Problem
- The equipment is not sealing.
- Inappropriate cut.
Probable cause
- Power input cable disconnected;
- Switch turned off ;
- Burned fuses;
- Bad adjustment of temperature;
- Lack of pressure to the lever;
- Before the fi rst sealing, time was
not enough to reach the adjusted
temperature;
- Burned resistor.
- Low speed while cutting;
- Knife does not cut anymore.
Solution
- Connect the cable to the plug
- Check the voltage;
- Turn on the switch (03);
- Replace the fuses;
- Adjust the temperature on the
switch(08);
- When operating the lever, put
more pressure and hold it for four
seconds;
- When the Sealer is turned on,
before the fi rst sealing, wait until
the LED indicator turns off ;
- Turn the equipment off and con-
tact the technical assistance.
- Pull the knife's handle quickly;
- Turn the equipment off and con-
tact the technical assistance.
55