Publicidad
Idiomas disponibles
Idiomas disponibles
2 - ENGLISH
SM600-1 & SM600-2 ENDURO™ PRO NON-POSITIONER
SERVO MOTOR USER INSTRUCTIONS
Congratulations!
You have purchased the Enduro™ Pro SM600 motor that pays for itself with a remarkable 60% to 80%
energy savings compared to clutch motors. With the high and rising cost of electricity, you just can't
afford to run a clutch motor any longer. The power and dependability of the brushless Enduro™ Pro
SM600 is adequate for light duty sewing.
Please read these instructions carefully before installation, operation or maintenance.
General Introduction
The Enduro™ Pro SM600 Servo Motor is designed to meet almost all basic light duty requirements of
various commercial sewing machines. It utilizes extremely powerful rare-earth Neodymium permanent
magnets. The motor produces almost no noise, saves energy and is brushless, speed adjustable and
durable. It provides a high starting torque even at low speed or from a complete stop.
By using a modern technologically advanced microprocessor, Hall sensor and Pulse-Width Modulation
technology, the Enduro™ Pro SM600 can be set to rotate at different maximum speeds, in either normal
or reverse directions, and can start with different accelerating speeds. It will stop automatically with any
interruption such as in-line voltage, electrical surge, radio frequency interference or overloading. It is
fully protected by the software and will give error messages indicating which problem is encountered. It
even works well in environments with an unstable electrical power supply.
CAUTION
1. Remove your foot from the pedal when turning the power ON.
2. Turn the power switch OFF before replacing or threading the needle.
3. Turn the power OFF when leaving the machine.
4. When performing maintenance on the sewing machine, turn the motor power switch to
the OFF position. Remove the power cord from the back of the motor to completely
disable all power to the sewing machine.
5. Always ground the grounding wire.
6. Always turn off the power switch before connecting or disconnecting each connector.
7. To avoid an accident, do not alter this motor and control box.
Warranty
This product is covered with a 1 year limited warranty. If the motor fails to perform its designed function
due to manufacturer's defects, contact the place you purchased it from for repair or replacement.
This warranty does not cover defects due to dropping, power surge, spikes or misuse.
Installation
Put the mounting bracket of the motor upwards to the bottom of the tabletop and fi x the motor to the
tabletop with the bolts provided. Connect the treadle rod with the connecting rod joint. Install the female
plug of the cable from the switch box into the power inlet socket in the back of the motor box.
www.endurosaves.com
Publicidad
