Publicidad
Idiomas disponibles
Idiomas disponibles
Wiring
For 110 volt single phase motor follow the diagram below:
For 220 volt single phase motor follow the diagram below:
Note: When wiring the motor to the power source, connect both the black and white wires to
achieve 220 Volts (green to ground). If you are in an area (China / Europe) that supplies 220 Volts
from a single lead, then connect the power source to the black wire. The white wire will then be the
neutral and the green wire will be the ground.
Error Message and Trouble Shooting
E2: Motor Phase signal error.
E3: Motor protected against over-current.
E4: Circuit board error.
E5: Display module and control module communication error.
E6: Pedal position sensor error.
Setting Up
Turn on the switch located on the switchbox. The display will
show roughly a circle with a running blinking bar, this means the
motor is in "ready" status, ready to work or be set.
www.endurosaves.com
ENGLISH - 3
"ready" status
Publicidad
