Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS U-HANDLE COMBO KIT
8.
Insert square nut (K) in lower handle u-handle bracket (L) and place
bracket on drive shaft 48.4 cm (19 in.) from engine end of drive
shaft. Secure with lower handle bracket clamp (M) and three (3)
5mm x 30mm hex socket screws.
9.
Position harness clamp 37.5 cm (14-3/4 in.) from engine end of drive
shaft assembly. DO NOT tighten at this time.
10. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8 mm x 55 mm bolt (N) and large circular washer.
11. Install power head and align gear box, power head and U-Handles.
Tighten all screws.
12. Route throttle linkage and ignition lead assembly behind U-Handle
bracket and clip to drive shaft as shown.
13. Place throttle linkage (E) through adjustment fixture (F) and install
wire end into large carburetor throttle swivel hole (D). Check
throttle for freedom of movement and that wide open throttle / low
idle extremes are adjusted properly. The throttle linkage must be
adjusted by moving the adjustment fixture (F). Consult with your
Echo Dealer for correct adjustment procedure.
K
L
M
48.4 cm (19 in.)
L
37.5 cm (14-3/4 in.)
N
E
C
A
F
5
ENGINE
END
D
Publicidad
