Wiseup L200 Guia Del Usuario página 3

3.3.2. Press the Power Button once to get into standby mode. The indicator light will flash white
twice and then be solid white.
3.3.3. Press the Power Button for 2 seconds to start video recording. The indicator light will keep
flashing white.
3.3.4. Press the Power Button once again to stop video recording. The indicator light will flash white
twice and then be solid white, indicating the camera is back to standby mode.
[Note]:
1). A video clip will be generated and saved every 30 minutes automatically.
2). The camera can record video for 1 hour continuously on a full charge.
3). If the camera is in low battery, the camera will save the video file and shut down automatically. The indicator
light will flash red once and then turn off.
3.4. CAMERA/STILL PHOTOGRAPHY
3.4.1. Power on the camera by holding down the Power Button for 2 seconds, the camera will enter
into sound-activated video recording mode automatically. The indicator light will glow solid white for
4 seconds and flash white once, then turn off.
3.4.2. Press the Power Button once to get into standby mode. The indicator light will flash white
twice and then be solid white.
3.4.3. Press the Power Button once to take a photo. Every time you take a photo, the indicator light
will flash white once.
IV. Video/Image Files Uploads
4.1. Power off the camera, remove the cap and plug the camera directly into a proper PC computer
USB port.
4.2. Removable disk drive folder appears.
4.3. All the files can be accessed in the drive.
V. Setting Time/Date Stamp
5.1. Power off the camera, remove the cap and plug the camera directly into a proper PC computer
USB port.
5.2. Removable disk drive folder appears.